Oct 13, 2025 Leave a message

What Is The Reason Why Gas Shielded Welding Robots Often Stick To Wires? How To Solve It?

Gas shielded welding robot, also known as gas shielded welding robot, is an automated welding equipment. It adopts gas shielded welding technology to protect the metal in the welding area with gas shielding, prevent oxidation during the welding process, and improve the welding quality. Wire sticking refers to the phenomenon in which the welding wire does not break smoothly after the welding process in automated welding, but continues to stick to the workpiece, forming paint droplets and causing quality problems. This situation is usually caused by welding parameters, improper surface treatment of the workpiece, bending of the welding gun, or robot position control issues.

 

 Reasons for wire sticking in gas shielded welding robots:

1. Incorrect welding parameter settings, such as excessive current, low voltage, and electrode failure to contact the workpiece.

2. Poor welding environment, such as oil stains, rust, moisture, etc. on the surface of the workpiece, can affect the welding quality.

3. The bare wires inside and outside the welding machine are too short to stably transport the welding wire.

4. Insufficient welding skills, such as unstable movement trajectory, welding speed, and uneven wire feeding.

5. Quality issues with welding wire, such as excessive wire diameter, too soft wire, and inappropriate melting point of welding wire.

 

news-891-794

 

 

 

Solution to wire sticking of gas shielded welding robot:

1. Ensure that the welding machine parameters are set correctly and make effective adjustments according to the welding process requirements.

2. Minimize environmental pollution as much as possible and keep the surface of the workpiece clean and dry.

3. Install high-quality fixtures that produce stable welding wire to ensure the normal transport of the welding wire.

4. Smooth welding motion and good control of welding speed to maintain a basic balance between wire input and welding volume.

5. Choose high-quality welding wire to ensure stable wire input and stable and uniform formation of the molten pool. At the same time, welding wire should avoid being too soft or too hard.

 

To avoid wire sticking problems in gas shielded welding robots, it is necessary to carefully adjust welding parameters, control welding gun bending or robot position according to welding requirements, in order to ensure stable and reliable welding quality.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry